Difference between revisions of "PVD/Independent Fabrications Disk Dropout"

From Pvdwiki
Jump to: navigation, search
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
I worked with Jeff at [http://www.ifbikes.com/ Independent Fabrications] to design a really special dropout. This is the result.
+
In 1999, I worked with Jeff at [http://www.ifbikes.com/ Independent Fabrications] to design a really special disc dropout to address the rising use of disc brakes on race frames. This is the result.
  
 
The design built upon the standard Paragon dropout IF was using at the time. The dropout was extended and shaped to make it look very nice on most frame sizes and be as strong as it needed to be with little weight.
 
The design built upon the standard Paragon dropout IF was using at the time. The dropout was extended and shaped to make it look very nice on most frame sizes and be as strong as it needed to be with little weight.
Line 6: Line 6:
  
 
[[Image:Pvd-If-drops.jpg]]
 
[[Image:Pvd-If-drops.jpg]]
 +
 +
[[Image:IF-dropouts2.jpg]]
  
 
[[category:Bicycle]]
 
[[category:Bicycle]]
 
[[category:Frame Building]]
 
[[category:Frame Building]]

Latest revision as of 14:31, 25 October 2008

In 1999, I worked with Jeff at Independent Fabrications to design a really special disc dropout to address the rising use of disc brakes on race frames. This is the result.

The design built upon the standard Paragon dropout IF was using at the time. The dropout was extended and shaped to make it look very nice on most frame sizes and be as strong as it needed to be with little weight.


Pvd-If-drops.jpg

IF-dropouts2.jpg