Grip Preparation: Difference between revisions

From Pvdwiki
Jump to navigationJump to search
Line 5: Line 5:
==Champhering the Clamp==
==Champhering the Clamp==
[[Image:Grips_5995.jpg]]
[[Image:Grips_5995.jpg]]
This is how the grip clamp is in stock form.


[[Image:Grips_5996.jpg]]
[[Image:Grips_5996.jpg]]
Both sides shown.


[[Image:Grips_5999.jpg]]
[[Image:Grips_5999.jpg]]
The clamp is clamped to a shaft on the lathe and set-up.


[[Image:Grips_6000.jpg]]
[[Image:Grips_6000.jpg]]
Time taken so as to not damage the screw.


[[Image:Grips_6004.jpg]]
[[Image:Grips_6004.jpg]]
This is what you are looking for.


[[Image:Grips_6006.jpg]]
[[Image:Grips_6006.jpg]]
The set.


[[Image:Grips_6009.jpg]]
[[Image:Grips_6009.jpg]]
Modified clamp re-attached to the grip.

Revision as of 18:25, 13 October 2006

Most bicycle grips are simply glued to the handlebars using grip cement. This is fine as long as the end is left exposed so that a delrin handlebar plug is allowed to protrude.

In seriously wet conditions, one of the best choices for grips are ODI Lock-On Grips. ODI Lock-On Grips require a few modifications.

Champhering the Clamp

This is how the grip clamp is in stock form.

Both sides shown.

The clamp is clamped to a shaft on the lathe and set-up.

Time taken so as to not damage the screw.

This is what you are looking for.

The set.

Modified clamp re-attached to the grip.