Handlebar Preparation

From Pvdwiki
Revision as of 22:39, 12 October 2006 by Pvd (talk | contribs) (Make and Install Delrin Plugs)
Jump to: navigation, search

Preparing mountain bike handlebars is quite simple, but easy to do wrong.

Cut to Length

I cut my example to about 25.5" These bars will be going onto a singlespeed, so a little wider is better. On a geared bike, I would cut them about an inch or so narrower.

Cutting handlebars too narrow results in extremely poor handling and leverage against the terrain. Leaving the bars too wide results in bumping trees or bridges too much, plus you are limited in terms of narrowest crossings.

Square and Clean up Ends

Make and Install Delrin Plugs

Delrinbarplug.png

Handlebar 5977.jpg

Handlebar 5976.jpg

Handlebar 5978.jpg

Handlebar 5981.jpg