Difference between revisions of "Grip Preparation"

From Pvdwiki
Jump to: navigation, search
Line 32: Line 32:
 
Modified clamp re-attached to the grip.
 
Modified clamp re-attached to the grip.
  
[[Category:bicycle controls]]
+
[[Category:Bicycle]]
 +
[[Category:Controls]]

Revision as of 19:58, 16 October 2006

Most bicycle grips are simply glued to the handlebars using grip cement. This is fine as long as the end is left exposed so that a delrin handlebar plug is allowed to protrude.

In seriously wet conditions, one of the best choices for grips are ODI Lock-On Grips. ODI Lock-On Grips require a few modifications. Without champhering the end of the clamp, the glamp will get marred during use. This marring will tear gloves in time, causing problems and expense. Also, the end of the clamp can be made far more comfortable with the addition of a large champher.

Champhering the Clamp

Grips 5995.jpg

This is how the grip clamp is in stock form.

Grips 5996.jpg

Both sides shown.

Grips 5999.jpg

The clamp is clamped to a shaft on the lathe and set-up.

Grips 6000.jpg

Time taken so as to not damage the screw.

Grips 6004.jpg

This is what you are looking for.

Grips 6006.jpg

The set.

Grips 6009.jpg

Modified clamp re-attached to the grip.