Difference between revisions of "Damping Handlebar Vibration"
| Line 14: | Line 14: | ||
The planned upgrade.<br> | The planned upgrade.<br> | ||
[[Image:Handlebar weight.gif]]<br> | [[Image:Handlebar weight.gif]]<br> | ||
| − | [http://www.pvdwiki.com/images/1/14/Handlebar_weight.pdf Drawing of part] | + | [http://www.pvdwiki.com/images/1/14/Handlebar_weight.pdf Drawing of part]<br> |
| − | + | Tapping the bar.<br> | |
[[Image:Barweight2.jpg]]<br><br> | [[Image:Barweight2.jpg]]<br><br> | ||
| + | The bar needs a 2mm step cut in it to work with the stock bar end.<br> | ||
[[Image:Barweight3.jpg]]<br><br> | [[Image:Barweight3.jpg]]<br><br> | ||
| + | Machining the step<br> | ||
[[Image:Barweight4.jpg]]<br><br> | [[Image:Barweight4.jpg]]<br><br> | ||
| + | Comparing the two configurations.<br> | ||
[[Image:Barweight5.jpg]]<br><br> | [[Image:Barweight5.jpg]]<br><br> | ||
| + | Stock parts. 130g. Not very heavy.<br> | ||
[[Image:Barweight6.jpg]]<br><br> | [[Image:Barweight6.jpg]]<br><br> | ||
| + | The new parts weigh 150g more than stock. Thats over 1/4 pound.<br> | ||
[[Image:Barweight7.jpg]]<br><br> | [[Image:Barweight7.jpg]]<br><br> | ||
[[Image:Barweight8.jpg]]<br><br> | [[Image:Barweight8.jpg]]<br><br> | ||
Revision as of 00:01, 7 November 2006
BUZZZZZZ....
A vibrating handgrip will cause discomfort and the hand to fall asleep. Weight is usually the fix.
The aftermarket has a few examples of large bolt on weights for clip-ons to fight this. If you can find some of these, give them a try.
Stock Clip-on Modification
Stock handlebars will almost always have some sort of weight inside. This is to reduce the vibrations at the bar. A problem for the non-racing rider is that these weights are kept to a minimum to score points with magazine editors regarding overall bike weight. So our bikes are light, but they hurt to ride. Let's choose to add a little weight and make the bike far more comfortable to ride.
The stock 2005 CBR600RR handlebar weight configuration.
The planned upgrade.
Drawing of part
Tapping the bar.
The bar needs a 2mm step cut in it to work with the stock bar end.
Machining the step
Comparing the two configurations.
Stock parts. 130g. Not very heavy.
The new parts weigh 150g more than stock. Thats over 1/4 pound.
