Difference between revisions of "PVD Rigid 29er Fork"
From Pvdwiki
(→Pictures) |
|||
Line 27: | Line 27: | ||
Welded up. Note the breather hole welded over.<br> | Welded up. Note the breather hole welded over.<br> | ||
[[Image:IMG 9464.jpg]]<br><br> | [[Image:IMG 9464.jpg]]<br><br> | ||
+ | |||
+ | Turning the crown race to perfection.<br> | ||
+ | [[Image:IMG 9454.jpg]]<br><br> | ||
+ | [[Image:IMG 9456.jpg]]<br><br> | ||
[[category:Bicycle]] | [[category:Bicycle]] | ||
[[category:Frame Building]] | [[category:Frame Building]] |
Revision as of 17:31, 11 May 2007
This is part of my first solo effort at framebuilding. I have been part of teams building frames, but this time it's all me.
The bike is a silly rigid niner. I got a nice deal on tubes, and wanted to try some geometry tricks. I do not take this bike seriously. It is a first try and will probably end up as my wifes work bike.
The Specs
16.75" Axle to Crown, axially to steerer.
50mm offset.
100mm spacing.
15" axle to bottom of steerer, axially to steerer.
7 degree blade angle, on center.
Nova niner fork blades.
1.125" steerer.
Pictures
Fitting the disk tab. Still some trimming to do.