Difference between revisions of "Spoke Threadlocker"
From Pvdwiki
(→Other Considerations) |
|||
| Line 18: | Line 18: | ||
===Other Considerations=== | ===Other Considerations=== | ||
* Grease or oil on the shoulder of the nipple or eyelet will make the build go much smoother, especially if using aluminum nipples. | * Grease or oil on the shoulder of the nipple or eyelet will make the build go much smoother, especially if using aluminum nipples. | ||
| − | * If building using a Mavic UST rim, the threaded eyelets should be fastened using Loctite 243 or equivilant as per [http://www.mavic.com/e_upload/pdf/UST_Rims_et_dismountable.pdf UST PDS] | + | * If building using a Mavic UST rim, the threaded eyelets should be fastened using [http://tds.loctite.com/tds5/docs/243-EN.PDF Loctite 243] or equivilant as per [http://www.mavic.com/e_upload/pdf/UST_Rims_et_dismountable.pdf UST PDS] |
Revision as of 23:44, 11 January 2007
Several excelent options exist for threadlockers on spokes.
Contents
Why a threadlocker
Threadlocker Etiquette
- Loctite threadlockers should never come in contact with plastics of any kind. The threadlocker will feed on the plastic and destroy it.
- Other than very special products, a threadlocker is designed to bond to clean, oil free surfaces. Oil will reduce or eliminate the strength of the bond.
- Activators may be used in certian cercumstances, but they reduce the strength of the threadlocker.
Pre-build Option
One of the best options available for threadlocking spokes is Loctite 242. I have personally used this for over 10 years. It is great.
If you have concerns about the threadlocking strength of 242, Loctite 222MS can be used instead. It is less powerful but less comonly available.
Post Build Option
If it is difficult or a wheel build must be done without 242 or 222MS at hand, Loctite 290 may be used after the build is done. This is not prefered, but acceptable in special cases.
Other Considerations
- Grease or oil on the shoulder of the nipple or eyelet will make the build go much smoother, especially if using aluminum nipples.
- If building using a Mavic UST rim, the threaded eyelets should be fastened using Loctite 243 or equivilant as per UST PDS
